LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2010 >> Accent GLS, Standard >> Repair and Diagnosis >> Steering >> Steering Control Systems >> General Information - Steering System >> General Information >> Service Adjustment Procedure >> Oil Pump Pressure Test

Oil Pump Pressure Test

  1. Disconnect the pressure hose from the pump. Connect the special tool between the pump and the pressure hose as illustrated.
  2. Bleed the air, and then start the engine and turn the steering wheel several times, measure the fluid temperature by Temperature gauge so that the fluid temperature can rise to approximately 50 °C (122 °F).
  3. Increase the engine speed to 1,000 RPM.
  4. Close the shut-off valve of the special tool and measure the fluid pressure to confirm that it is within the standard value range.

    Standard value 

    Oil pump pressure

    Relief pressure:

    6.6 ~ 7.3 mPa (68 ~ 75 kg/cm2 , 967 ~ 1066 psi)

    CAUTION: Do not keep the shut-off valve on the pressure gauge closed for more than ten seconds.
    Fig 1: Checking Oil Pump Pressure
    G06882335Courtesy of HYUNDAI MOTOR CO.
  5. Remove the special tools, and tighten the pressure hose against the oil pump using the specified torque.

    Tightening torque: 

    55 ~ 65 N.m (5.5 ~ 6.5 kgf.m, 40 ~ 47 lb-ft)

  6. Bleed the air in the system.