LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2010 >> Accent GLS, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Cylinder Block >> Repair Procedures >> Disassembly

Repair Procedures: Disassembly

  1. M/T : Remove the fly wheel.
  2. A/T : Remove the drive plate.
  3. Install the engine to engine stand for disassembly.
  4. Remove the timing belt.
  5. Remove the cylinder head.
  6. Remove the oil level gauge tube (A).
    Fig 1: Locating Oil Level Gauge Tube
    G06879143Courtesy of HYUNDAI MOTOR CO.
  7. Remove the knock sensor (A).
    Fig 2: Locating Knock Sensor
    G06879144Courtesy of HYUNDAI MOTOR CO.
  8. Remove the oil pressure switch (A).
    Fig 3: Locating Oil Pressure Switch
    G06879145Courtesy of HYUNDAI MOTOR CO.
  9. Remove the water pump.
  10. Remove the oil pan (A).
    Fig 4: Locating Oil Pan
    G06879146Courtesy of HYUNDAI MOTOR CO.
  11. Remove the oil screen.

    Remove the 2 bolts (C), oil screen (A) and gasket (B).

    Fig 5: Locating Bolts, Oil Screen And Gasket
    G06879147Courtesy of HYUNDAI MOTOR CO.
  12. Check the connecting rod end play.
  13. Remove the connecting rod caps and check oil clearance.
  14. Remove the piston and connecting rod assemblies.
    1. Using a ridge reamer, remove all the carbon from the top of the cylinder.
    2. Push the piston, connecting rod assembly and upper bearing through the top of the cylinder block.
      NOTE:
      • Keep the bearings, connecting rod and cap together.
      • Arrange the piston and connecting rod assemblies in the correct order.
  15. Remove the front case.
  16. Remove the rear oil seal case.

    Remove the 5 bolts (B) and rear oil seal case (A).

    Fig 6: Locating Bolts And Rear Oil Seal Case
    G06879148Courtesy of HYUNDAI MOTOR CO.
  17. Remove the crankshaft bearing cap and check oil clearance.
  18. Check the crankshaft end play.
  19. Lift the crankshaft (A) out of the engine, being careful not to damage journals.
    NOTE: Arrange the main bearings and thrust bearings in the correct order.
    Fig 7: Locating Crankshaft
    G06879149Courtesy of HYUNDAI MOTOR CO.
  20. Check fit between piston and piston pin.

    Try to move the piston back and forth on the piston pin.

    If any movement is felt, replace the piston and pin as a set.

  21. Remove the piston rings.
    1. Using a piston ring expender, remove the 2 compression rings.
    2. Remove the 2 side rails and oil ring by hand.
      NOTE: Arrange the piston rings in the correct order only.
  22. Remove the connecting rod from the piston.

    Using a press, remove the piston pin from piston.

    (Press-in load : 500 ~ 1,500 kg (1,102 ~ 3,306 lb))