LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2009 >> Veracruz GLS, AWD >> Repair and Diagnosis >> Engine Performance >> System >> DTC Troubleshooting Procedures (2 Of 2) >> DTC Troubleshooting Procedures >> DTC P2096: Post Catalyst Fuel Trim System Too Lean (Bank 1) >> Monitor Scan Tool Data

Monitor Scan Tool Data

NOTE: If any codes relating to Rear HO2S or TWC (Three Way Catalyst Converter) are stored, do ALL REPAIRS associated with those codes before proceeding with this troubleshooting tree.
  1. Check DTC Status
    1. Connect scan tool to Data Link Connector (DLC)
    2. IG "ON".
    3. Select "DTC" button, and then Press DTC Status" to check DTC's information from the DTCs menu
    4. Read "DTC Status" parameter.
      Fig 1: Scan Tool Display - DTC Status
      G05329785Courtesy of HYUNDAI MOTOR CO.
    5. Is parameter displayed "History (Not Present) fault"?
      NOTE:
      • History (Not Present) fault : DTC occurred but has been cleared.
      • Present fault : DTC is occurring at present time.

      YES 

      • Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

      • Go to "Component Inspection" procedure.