LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2009 >> Veracruz GLS, AWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Smart Key System >> Troubleshooting >> B1583 Park Position Error >> Monitor DTC Status

Monitor DTC Status

  1. Connect scantool to Data Link Connector (DLC).
  2. Engine "ON"
  3. Operate the vehicle within DTC Enable conditions in General information.
  4. Monitor the "PARKING SW" parameter on the scantool.

    Specification  : "PARKING SW" parameter "OFF"

    Fig 1: Screen Display - Current Data
    G06207865Courtesy of HYUNDAI MOTOR CO.
  5. Is the monitored parameter within specifications?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

      Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

    • Go to "Inspection/Repair" procedure.