LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Tucson SE, 4WD >> Repair and Diagnosis >> Transmission >> Transfer Case Assembly >> DTC Troubleshooting Procedure >> DTC P1728 EMC Open/Shorted To Battery >> Signal Circuit Inspection

Signal Circuit Inspection

  1. EMC Signal Inspection
    1. IG KEY ON, ENG IDLE
    2. EMC connector: Connect.
    3. Monitor signal waveform between terminal 1 of F43 harness connector and chassis ground.
    4. Shift to N Range.

      Specification: refer to 'WAVEFORM INSPECTION '

      Is EMC Signal display near the specified value?

      YES  : --> This may be caused by intermittent fault. Verify data changeability by shaking the harness.

      NO  : Keep 0V continuously.

      • Inspect open or short in EMC output line.
      • Check for 4WD ECM and replace it as necessary.

        Keep B+ continuously

      • Inspect open or short in EMC component inspection.
  2. EMC output line open inspection
    1. IG KEY OFF, ENG OFF
    2. Electric Magnet Valve Clutch connector and 4WD ECM connector: Disconnect.
    3. Measure resistance between terminal 1 of Electric Magnet Valve Clutch harness connector and terminal 26 of 4WD ECM harness connector.

      Specification: Approx. 0Ω

      Is resistance display near the specified value?

      YES  : --> Proceed to next inspection procedure.

      NO  : --> Repair open circuit of EMC output harness.

      --> If problem is solved, go to the "VERIFICATION OF VEHICLE REPAIR ".

      Fig 1: Open Circuit Of EMC Output Harness - Circuit Diagram
      G04811016Courtesy of HYUNDAI MOTOR CO.
  3. EMC ground line open inspection
    1. IG KEY OFF, ENG OFF
    2. Electric Magnet Valve Clutch connector and 4WD ECM connector: Disconnect.
    3. Measure resistance between terminal 2 of Electric Magnet Valve Clutch harness connector and terminal 13 of 4WD ECM harness connector M79.

      Specification: Approx. 0Ω

      Is resistance display near the specified value?

      YES  : --> Go to "COMPONENT INSPECTION " procedure.

      NO  : --> Repair open circuit of EMC ground harness.

      --> If problem is solved, go to the "VERIFICATION OF VEHICLE REPAIR ".

      Fig 2: Open Circuit Of EMC Ground Harness - Circuit Diagram
      G04811017Courtesy of HYUNDAI MOTOR CO.