LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Tucson SE, 4WD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G6BA - GSL 2.7) >> DTC Troubleshooting Procedures >> DTC U0101 Serial Communication Problem With TCU (Timeout) >> Signal Circuit Inspection >> Check Can Communication Line For Short To Battery

Check Can Communication Line For Short To Battery

  1. Disconnect the connectors related to the CAN communication
  2. Ignition "ON" & Engine "OFF"
  3. Measure voltage between terminal 36 of the ECM harness connector and chassis ground.
  4. Measure voltage between terminal 37 of the ECM harness connector and chassis ground.

    Specification: Approx. 0V

    Fig 1: Measuring Voltage Between Terminal 37 Of ECM Harness Connector And Chassis Ground
    G04810178Courtesy of HYUNDAI MOTOR CO.
  5. Is voltage within the specification?

    YES  : --> Go to next step as below.

    NO  : --> Repair CAN communication line for a short to battery. And then go to "VERIFICATION OF VEHICLE REPAIR " procedure.