Signal Circuit Inspection
- Check for open in signal harness.
- Ignition "OFF".
- Measure resistance between terminals 2 of the sensor harness connector and 31 of the ECM harness connector.
Specification: Approx. 0Ω
- Is resistance within the specification?
YES : --> Go to next step as below
NO
--> Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Check for short to ground in signal harness.
- Ignition "OFF"
- Measure resistance between terminal 2 of the sensor harness connector and chassis ground
Specification: Infinite
- Is resistance within the specification?
YES : --> Go to next step as below
NO : --> Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Check for short to power in signal harness.
- Ignition "OFF"
- Disconnect ECM connector
- Ignition "ON" & Engine "OFF"
- Measure voltage between terminal 2 of the sensor harness connector and chassis ground
Specification: Approx. 0V
- Is voltage within the specification?
YES : --> Go to "COMPONENT INSPECTION " procedure.
NO : --> Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.