LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Tucson SE, 4WD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G6BA - GSL 2.7) >> DTC Troubleshooting Procedures >> DTC P0325 Knock Sensor 1 Circuit >> Signal Circuit Inspection

Signal Circuit Inspection

  1. Check for open in signal harness.
    1. Ignition "OFF".
    2. Measure resistance between terminals 2 of the sensor harness connector and 29 of the ECM harness connector.

      Specification: Approx. 0Ω

      Fig 1: Measuring Resistance Between Sensor Harness Connector And ECM Harness Connector
      G04810401Courtesy of HYUNDAI MOTOR CO.
    3. Is resistance within the specification?

      YES  : --> Go to next step as below

      NO  : --> Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

  2. Check for short to ground in signal harness.
    1. Ignition "OFF"
    2. Measure resistance between terminal 2 of the sensor harness connector and chassis ground

      Specification: Infinite

      Fig 2: Measuring Resistance Between Sensor Harness Connector And Chassis Ground
      G04810402Courtesy of HYUNDAI MOTOR CO.
    3. Is resistance within the specification?

      YES  : --> Go to next step as below

      NO  : --> Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

  3. Check for short to power in signal harness.
    1. Ignition "OFF"
    2. Disconnect ECM connector
    3. Ignition "ON" & Engine "OFF"
    4. Measure voltage between terminal 2 of the sensor harness connector and chassis ground

      Specification: Approx. 0V

      Fig 3: Measuring Resistance Between Sensor Harness Connector And Chassis Ground
      G04810402Courtesy of HYUNDAI MOTOR CO.
    5. Is voltage within the specification?

      YES  : --> Go to "COMPONENT INSPECTION " procedure.

      NO  : --> Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.