LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Tucson SE, 4WD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G6BA - GSL 2.7) >> DTC Troubleshooting Procedures >> DTC P0230 Fuel Pump Primary Circuit >> Control Circuit Inspection

Control Circuit Inspection

  1. Check for short to ground in control circuit.
    1. Ignition "OFF" & Relay connector: Disconnected.
    2. Measure resistance between terminal 3 of the relay harness connector and chassis ground.

      Specification: Infinite

      Fig 1: Measuring Resistance Between Relay Harness Connector And Chassis Ground
      G04810377Courtesy of HYUNDAI MOTOR CO.
    3. Is resistance within the specification?

      YES  : --> Go to next step as below.

      NO  : --> Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

  2. Check for short to power in control circuit.
    1. Disconnect ECM connector.
    2. Ignition "ON" and Engine "OFF".
    3. Measure voltage between terminal 3 of the relay harness connector and chassis ground.

      Specification: Approx 0V

      Fig 2: Measuring Voltage Between Relay Harness Connector And Chassis Ground
      G04810378Courtesy of HYUNDAI MOTOR CO.
    4. Is voltage within the specification?

      YES  : --> Go to next step as below

      NO  : --> Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

  3. Check for open in control harness.
    1. Measure resistance between terminals 3 of the relay harness connector and 10 of the ECM harness connector.

      Specification: Approx 0Ω

      Fig 3: Measuring Resistance Between Relay Harness Connector And ECM Harness Connector
      G04810379Courtesy of HYUNDAI MOTOR CO.
    2. Is resistance within the specification?

      YES  : --> Thoroughly check connectors for loose or poor connections, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO  : --> Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.