LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Tucson SE, 4WD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G6BA - GSL 2.7) >> DTC Troubleshooting Procedures >> DTC P0122 Throttle/Pedal Position Sensor/Switch "A" Circuit Low Input >> Signal Circuit Inspection

Signal Circuit Inspection

  1. Ignition "ON" & Engine "OFF".
  2. Measure voltage between terminal 3 of the sensor harness connector and chassis ground.

    Specification: Approx. 5V

    Fig 1: Measuring Voltage Between Sensor Harness Connector And Chassis Ground
    G04810296Courtesy of HYUNDAI MOTOR CO.
  3. Is voltage within the specification?

    YES  : Go to "COMPONENT INSPECTION " procedure.

    NO  : Check the short to ground in signal circuit.

    Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.