LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Tucson SE, 4WD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G6BA - GSL 2.7) >> DTC Troubleshooting Procedures >> DTC P0118 Engine Coolant Temperature Circuit High Input >> Signal Circuit Inspection

Signal Circuit Inspection

  1. Check for open in signal circuit.
    1. Measure resistance between terminals 3 of the ECT sensor harness connector and 24 of the ECM harness connector.

      Specification: Approx. 0Ω

      Fig 1: Measuring Resistance Between ECT Sensor Harness Connector And ECM Harness Connector
      G04810282Courtesy of HYUNDAI MOTOR CO.
    2. Is resistance within the specification?

      YES  : --> Go to next step as below.

      NO  : --> Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

  2. Check for short to battery in signal circuit.
    1. Ignition "ON" & Engine "OFF".
    2. Measure voltage between terminals 3 of the ECT sensor harness connector and 24 of the ECM harness connector.

      Specification: Approx. 0V

      Fig 2: Measuring Voltage Between ECT Sensor Harness Connector And ECM Harness Connector
      G04810283Courtesy of HYUNDAI MOTOR CO.
    3. Is voltage within the specification?

      YES  : --> Go to "TERMINAL AND CONNECTOR INSPECTION " procedure.

      NO  : --> Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.