LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Tucson SE, 4WD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G6BA - GSL 2.7) >> DTC Troubleshooting Procedures >> DTC P0116 Engine Coolant Temperature Circuit Range/Performance >> DTC Detecting Condition

DTC P0116 Engine Coolant Temperature Circuit Range/Performance: DTC Detecting Condition

DTC DETECTING CONDITION CHART

ITEM DETECTING CONDITION POSSIBLE CAUSE
Case1) DTC Strategy
  • Check coolant temperature signal stuck.
  • Contact resistance in connections.
  • Faulty ECT sensor
Enable Conditions
  • Time after start if intake air temperature is below -30°C (-22°F): 250 sec.
Threshold Value
  • Model coolant temperature increase > Threshold But Measured coolant temperature increase < Threshold (Threshold depends on Coolant start temperature)
Diagnostic Time
  • 0.5 sec.
Case2) DTC Strategy
  • Signal Unplausible High with Long Soaking Condition
Enable Conditions
  • No Relevant Failure
  • Engine run Elapse of Previous DC > 500s or ECT at Engine Stop of Prev. DC > 85°C (185°F)
  • During model coolant temperature increase
  • IAT Signal Decrease Energy < 50J by Air Flow after Start
  • Cumulative Time for IAT Signal > 70s decrease Check (Air Flow > 60 kg/h) Cumulative Time for IAT Signal > 100s decrease Check [VS > 71 km/h (44 mph)]
Threshold Value
  • Measured coolant temperature at IAT start > 54°C (129°F) with IAT last DC - IAT start > 12°C (54°F) and IAT at Start
Diagnostic Time
  • Immediate if Enable Conditions Fullfilled