Signal Circuit Inspection
- Check for open in signal circuit.
- Measure resistance between terminals 3 of the ECT sensor harness connector and 24 of the ECM harness connector.
Specification: Approx. 0Ω
- Is resistance within the specification?
YES : --> Go to next step as below.
NO : --> Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Measure resistance between terminals 3 of the ECT sensor harness connector and 24 of the ECM harness connector.
- Check for short to battery in signal circuit.
- Ignition "ON" & Engine "OFF".
- Measure voltage between terminals 3 of the ECT sensor harness connector and 24 of the ECM harness connector.
Specification: Approx. 0V
- Is voltage within the specification?
YES : --> Go to "TERMINAL AND CONNECTOR INSPECTION " procedure.
NO : --> Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.