LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Tucson GLS, 4WD >> Repair and Diagnosis >> Transmission >> Transfer Case Assembly >> DTC Troubleshooting Procedure >> DTC P1719 Steering Wheel Angle Sensor C-Input Signal >> Signal Circuit Inspection

Signal Circuit Inspection

  1. Steering angle sensor center Signal Inspection
    1. IG KEY ON, ENG ON
    2. 4WD ECM, Steering angle sensor connector: Connect.
    3. Monitor signal waveform between terminal 1 of Steering angle sensor harness connector M14 and chassis ground.
    4. Rotate the steering wheel both ways.

      Specification: refer to 'WAVEFORM INSPECTION '

      Is Steering angle sensor center Signal display near the specified value?

      YES  : --> This may be caused by intermittent fault. Verify data changeability by shaking the harness.

      NO  : --> Inspect power and power supply line of Steering angle sensor center circuit.

      • Inspect ground and ground line of Steering angle sensor center circuit.
      • Inspect ground to short of Steering angle sensor center circuit.
      • Inspect open or short of Steering angle sensor center circuit.
      • Check for Steering angle sensor module and replace it as necessary.
      • Check for 4WD ECM and replace it as necessary.
  2. Steering angle sensor center signal short to ground Inspection
    1. IG KEY OFF, ENG OFF
    2. 4WD ECM connector and Steering angle sensor connector: Disconnect.
    3. Measure resistance between terminal 1 of Steering angle sensor harness connector M14 and chassis ground.

      Specification: Approx. ∞Ω

      Is resistance display near the specified value?

      YES  : --> Proceed to next inspection procedure.

      NO  : --> Repair ground to short circuit of Steering angle sensor center circuit.

      --> If problem is solved, go to the "VERIFICATION OF VEHICLE REPAIR "

      Fig 1: Ground To Short Circuit - Steering Angle Sensor Circuit Diagram
      G04811004Courtesy of HYUNDAI MOTOR CO.
  3. Steering angle sensor center signal open Inspection
    1. IG KEY OFF, ENG OFF
    2. 4WD ECM connector and Steering angle sensor connector: Disconnect.
    3. Measure resistance between terminal 1 of Steering angle sensor harness connector M14 and terminal 11 of 4WD ECM harness connector.

      Is resistance display near the specified value?

      YES  : --> Replace with normal Steering angle sensor module temporarily and check if vehicle runs normally. If trouble disappears, replace Steering angle sensor control module.

      • Replace with normal 4WD ECM temporarily and check if vehicle runs normally. If trouble disappears, replace 4WD ECM.
      • If problem is solved, go to the "VERIFICATION OF VEHICLE REPAIR ".

      NO  : --> Repair open circuit of Steering angle sensor center circuit.

      --> If problem is solved, go to the "VERIFICATION OF VEHICLE REPAIR ".

      Fig 2: Open Circuit Of Steering Angle Sensor Center Circuit Diagram
      G04811005Courtesy of HYUNDAI MOTOR CO.