LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Tiburon GS, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G4GC-GSL 2.0L) >> DTC Troubleshooting Procedures >> U0001 Can Communication Malfunction >> Can Low Line Inspection

Can Low Line Inspection

  1. Check for Open in harness.

      [With ABS]

    1. Measure resistance between terminals 6 of the PCM harness connectors and 22 of the ESC control module harness connector.

      Specification: Approx. 0Ω

      Fig 1: Measuring Resistance Between Terminals 6 Of PCM Harness Connectors And 22 Of ESC Control Module Harness Connector
      G00455240Courtesy of HYUNDAI MOTOR CO.
    2. Is resistance within the specification?

      YES: 

      • Go to step  2.

      NO: 

    3. [Without ESC]

    4. Measure resistance between terminals 6 of the PCM harness connectors and 1 of the vertical resistor.

      Specification: Approx. 0Ω

      Fig 2: Measuring Resistance Between Terminals 6 Of PCM Harness Connectors And 1 Of Vertical Resistor
      G00455241Courtesy of HYUNDAI MOTOR CO.
    5. Is resistance within the specification?

      YES: 

      • Go to  2

      NO: 

  2. Check for short to ground in harness.
    1. Measure resistance between terminals 6 of the PCM harness connectors and chassis ground.

      Specification: Infinite

      Fig 3: Measuring Resistance Between Terminals 6 Of PCM Harness Connectors And Chassis Ground
      G03849320
    2. Is resistance within the specification?

      YES: 

      • Go next step.

      NO: 

  3. Check for short to battery in harness.
    1. Ignition "ON" & Engine "OFF".
    2. Measure resistance between terminals 6 of the PCM harness connectors and chassis ground.

      Specification: Approx. 0V

      Fig 4: Measuring Resistance Between Terminals 6 Of PCM Harness Connectors And Chassis Ground
      G03849320

      YES: 

      • Using a scan tool, check PCM software version and upgrade as necessary. If version is the newest one, go to "Verification of Vehicle Repair" procedure.

      NO: