LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Tiburon GS, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G4GC-GSL 2.0L) >> DTC Troubleshooting Procedures >> DTC P0011 "A" Camshaft Position-Timing Over-Advanced Or System Performance (Bank 1) >> Component Inspection >> Oil Control Valve Operation Check >> Notes

Oil Control Valve Operation Check: Notes

[With Scan Tool]

  1. Ignition "ON" & Engine "OFF"
  2. Install scan tool and select "CVVT VALVE" on the Actuation Test mode.
  3. Activates "CVVT VALVE" by pressing "STRT (F1)" key (should hear a faint click from oil control valve)
  4. Repeat this procedure 4 or 5 times to ensure oil control valve reliability.
  5. [Without Scan Tool]

  6. Ignition "OFF".
  7. Remove the oil control valve from the engine.
  8. Visually check the Spool Column of oil control valve for contamination.
  9. Connect 12V and a ground to 2 and 1 of the solenoid (Component side). Verify that the spool column moves to the left as shown in the figure.
  10. Disconnect 12V and verify that spool column move to original condition.
  11. Fig 1: Identifying Spool Column Moves To The Left
    G03849136Courtesy of HYUNDAI MOTOR CO.
  12. Has a problem been found?

    YES: 

    NO: 

    • Go to next step below