LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Sonata GLS, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle System (F4A42) >> DTC P0721 Output Speed Sensor Circuit Range/Performance >> Monitor SCANTOOL Data

Monitor SCANTOOL Data

  1. Connect scantool to data link connector (DLC).
  2. Engine "ON".
  3. Monitor the "OUTPUT SPEED SENSOR" parameter on the scantool.
  4. Driving at speed of over 30 Km/h (19 mph).

    Specification : Increasing Gradually

    Fig 1: Scan Tool Display Screen - Output Speed Sensor Parameter
    G04811282Courtesy of HYUNDAI MOTOR CO.
  5. Does "output speed sensor" follow the reference data?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or TCM (PCM)'s connector or was repaired and TCM (PCM) memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage. Repair or replace as necessary and go to "VERIFICATION VEHICLE REPAIR " procedure.

    NO