LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Entourage GLS >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Immobilizer Control System >> Immobilize Control System >> DTC P1690 SMARTRA No Response >> Signal Circuit Inspection

Signal Circuit Inspection

  1. Check for open in harness
    1. Ignition "OFF"
    2. Disconnect SMARTRA.
    3. Measure resistance between terminal "5" of SMARTRA and terminal "45" of ECM

      Specification : 1 Ω or less

      Fig 1: Measuring Resistance Between Terminal "5" Of SMARTRA And Terminal "45" Of ECM
      G05325521Courtesy of HYUNDAI MOTOR CO.
    4. Is the measured resistance within specifications?

      YES 

      Go to " 2Check for short in harness" procedure.

      NO 

      Check for open in harness. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

  2. Check for short in harness
    1. Ignition "OFF"
    2. Disconnect SMARTRA.
    3. Ignition "ON" & Engine "OFF"
    4. Measure voltage value between terminal "5" of SMARTRA and chassis ground.

      Specification: Approx. 5.48V

      Fig 2: Measuring Voltage Value Between Terminal "5" Of SMARTRA And Chassis Ground
      G05325522Courtesy of HYUNDAI MOTOR CO.
    5. Is the measured voltage within specifications?

      YES 

      Go to "SIGNAL CIRCUIT INSPECTION " procedure

      NO 

      Check for short in harness. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.