LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Entourage GLS >> Repair and Diagnosis (Single Page) >> Brakes >> Traction Control >> Abs (Anti-Lock Brake System) >> Abs (Anti-Lock Brake System) >> DTC C1260 Steering Angle Sensor-Signal >> Monitor SCANTOOL Data

Monitor SCANTOOL Data

  1. Connect scantool to Data Link Connector (DLC).
  2. Ignition "ON" & Engine "ON".
  3. Turn the steering wheel to the left or right.
  4. Monitor the "steering sensor" parameters on the Scantool.

    Fig 1) Test Condition : Ignition "ON" & Engine "ON" Normal data (There are difference in displayed Normal data

    Fig 1: Identifying Scan Tool Display Screen - CURRENT DATA
    G05323176Courtesy of HYUNDAI MOTOR CO.
  5. Whenever steering wheel is turned, is the steering sensor's scantool data changed?

    YES 

    • Fault is intermittent caused by poor connection in steering sensor harness and/or HECU's connector or was repaired and HECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO