Signal Circuit Inspection
- Ignition "ON" & Engine "OFF"
- Install Scantool and monitor the "MASS AIR FLOW (V)" parameter on the Scantool data list.
Specification : Approx. 0.1V
- Is "MASS AIR FLOW (V)" within specification?
YES
- Go to next step as below
NO
- Possibility of wiring harness or component malfunction
- Below 0.1V : Check for open or short to ground in signal circuit
- Above 5V : Check for short to battery in signal circuit
- Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- If OK, go to next step as below