LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2007 >> Elantra SE, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G4GC-GSL 2.0) >> DTC Troubleshooting Procedures >> DTC P0011 "A" Camshaft Position-Timing Over-Advanced Or System Performance (Bank 1) >> Component Inspection >> Notes

Component Inspection: Notes

CHECK OCV AND FILTER 

  1. Check resistance of OCV.
    1. Ignition "OFF"
    2. Disconnect intake OCV connector.
    3. Measure resistance between terminals 1 and 2 of the intake OCV connector (Component side).

      Specification : Approx. 6.9~7.9Ω at 20°C (68°F)

    4. Is resistance within the specification?

      YES 

      • Go to next step as below.

      NO 

  2. Check operation of OCV
    1. Start the engine and let it idle.
    2. With OCV connector still disconnected, connect 12V and a ground to 2 and 1 of the OCV (Component side).

      SPECIFICATION : 

      OCV SPECIFICATION

      Test Condition Disconnect OCV connector Apply battery voltage
      Normal Value Normal engine speed Rough idle or engine stall
    3. Has a problem been found?

      YES 

      • Go to next step as below.

      NO 

  3. Check OCV and Filter.
    1. Ignition "OFF"
    2. Check OCV filter for sticking or contamination.
    3. Remove the OCV and visually check the spool column of OCV for contamination.
    4. Has a problem been found?

      YES 

      NO 

      • Go to next step as below.
    5. Apply 12V and a ground to 2 and 1 terminals of the OCV (Component side).
    6. Verify that a "clicking" sound is heard when applying the battery voltage.
    7. Repeat this procedure 4 or 5 times to ensure intake OCV reliability.
      Fig 1: Checking OCV And Filter
      G05363750
    8. Is OCV working properly?

      YES 

      • Go to next step as below.

      NO 

      • Check OCV for contamination, deterioration, or damage. Substitute with a known-good OCV and check for proper operation. If the problem is corrected, replace OCV and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.