Monitor SCANTOOL Data
- Connect scantool to data link connector (DLC).
- Engine "ON".
- Monitor the "CAN COMMUNICATION SERVICE DATA (ENGINE RPM, VEHICLE SPEED SENSOR, THROTTLE P. SENSOR)" parameters on the scantool.
- Compare it with reference data as below.
- Does "CAN BUS LINE DATA" follow the reference data?
YES : --> Fault is intermittent caused by poor contact in the sensor's and/or TCM's connector or was repaired and TCM memory was not cleared. And go to VERIFICATION OF VEHICLE REPAIR procedure.
NO : --> Substitute with a known-good TCM and check for proper operation.
If the problem is corrected, replace TCM as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.