LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2005 >> Tiburon GT, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G6BA-GSL 2.7L) >> DTC Troubleshooting Procedures >> DTC P0335 Crankshaft Position Sensor A Circuit >> Signal Circuit Inspection

Signal Circuit Inspection

  1. Check for open in signal harness.
    1. Disconnect ECM connector.
    2. Measure resistance between terminals 2 of the sensor harness connector and 8 of the ECM harness connector.

      Specification: Approx. 0ohm

    3. Is resistance within the specification?

      YES: 

      • Go to step  2 .

      NO: 

  2. Check for short to ground in signal harness.
    1. Measure resistance between terminal 2 of the sensor harness connector and chassis ground

      Specification: Infinite

    2. Is resistance within the specification?

      YES: 

      • Go to step  3 .

      NO: 

  3. Check for short to power in signal harness.
    1. Ignition "ON" & Engine "OFF".
    2. Measure voltage between terminal 2 of the sensor harness connector and chassis ground.

      Specification: Approx. 0V

    3. Is voltage within the specification?

      YES: 

      NO: