LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2005 >> Tiburon GT, Automatic >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G6BA-GSL 2.7L) >> DTC Troubleshooting Procedures >> DTC P0335 Crankshaft Position Sensor A Circuit >> Component Inspection

Component Inspection

  1. Start engine and let vehicle idle
  2. Connect scan tool and select "Current Data" mode
  3. Monitor "CKP T/WHEELS-LO CMP" & "CKP T/WHEELS-HI CMP" parameters on the Scan Tool data list.

    Specification:

    "CKP T/WHEELS-LO CMP": 38 +/- 4 tooth

    "CKP T/WHEELS-HI CMP": 98 +/- 4 tooth

    Fig 1: Display "CKP T/Wheels-LO CMP" & "CKP T/Wheels-HI CMP" Parameters
    G03849539Courtesy of HYUNDAI MOTOR CO.
  4. Are "CKP T/WHEELS-LO CMP" & "CKP T/WHEELS-HI CMP" parameters within the specification?

    YES: 

    • Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR  " procedure.

    NO: 

    • Remove CKP and calculate air gap between sensor and flywheel/torque converter. Readjust as necessary and go to next step.
      NOTE: Air gap [0.3~1.7 mm [0.012~0.067 in] - measure distance from hosing to teeth on flywheel/torque converter (measurement "A") and from mounting surface on sensor to sensor tip (measurement "B") subtract "B" from "A".
    • If fail to synchronize with CMP sensor, readjust timing system and go to next step.

    Check CKP sensor for contamination, deterioration, or damage. Substitute with a known-good CKP sensor and check for proper operation. If the problem is corrected, replace CKP sensor and then go to "VERIFICATION OF VEHICLE REPAIR  " procedure.