LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2005 >> Tiburon GS, Standard >> Repair and Diagnosis >> Engine Performance >> Tune-Up >> Ignition System >> On-Vehicle Inspection >> Inspect Spark Plug And Spark Plug Cable

Inspect Spark Plug And Spark Plug Cable

  1. Remove the spark plug cable (A).
    NOTE: When removing the spark plug cable, pull on the spark plug cable boot (not the cable), as it may be damaged.
  2. Using a spark plug socket, remove the spark plug (B).
    CAUTION: Be careful that no contaminates enter through the spark plug holes.
  3. Inspect the electrodes (A) and ceramic insulator (B).
    Fig 1: Inspecting Electrodes And Ceramic Insulator
    G03849023Courtesy of HYUNDAI MOTOR CO.
    INSPECTION OF ELECTRODES

    CONDITION DARK DEPOSITS WHITE DEPOSITS
    DESCRIPTION
    • Fuel mixture too rich
    • Low air intake
    • Fuel mixture too lean
    • Advanced ignition timing
    • Insufficient plug tightening
  4. Check the electrode gap (A).

    Standard (New) 

    1.0~1.1 mm (0.039~0.043 in.)

    Fig 2: Checking Electrode Gap
    G03849024Courtesy of HYUNDAI MOTOR CO.
  5. Carefully remove the spark plug cable by pulling on the rubber boots (A).

    Check the condition of the spark plug cable terminals (B), If any terminal is corroded, clean it, and if it's broken or distorted, replace the spark plug cable.

    Fig 3: Checking Condition Of Spark Plug Cable Terminals
    G03849025Courtesy of HYUNDAI MOTOR CO.
  6. Connect the ohmmeter probes and measure resistance.

    RESISTANCE: 5.6Kohm/m +/- 20%

    Fig 4: Connecting Ohmmeter Probes And Measuring Resistance
    G03849026Courtesy of HYUNDAI MOTOR CO.
  7. Resistance should not be higher than 2.6kohm per meter of cable.

    If resistance is higher, replace the cable.