LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2005 >> Tiburon GS, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G4GC-GSL 2.0L) >> DTC Troubleshooting Procedures >> DTC P0600 Can Communication Bus >> Terminal And Connector Inspection >> Can Low Line Inspection

Can Low Line Inspection

  1. Check for Open in harness.

    [With ABS]

    1. Measure resistance between terminals 6 of the PCM harness connectors and 10 of the ABS control module harness connector.

      Specification: Approx. 0ohm

      Fig 1: Measuring Resistance Between Terminals 6 Of PCM Harness Connectors And 10 Of ABS Control Module Harness Connector
      G03849317Courtesy of HYUNDAI MOTOR CO.
    2. Is resistance within the specification?

      YES: 

      • Go to  2 .

      NO: 

      [Without ABS]

    3. Measure resistance between terminals 6 of the PCM harness connectors and 2 of the vertical resistor.

      Specification: Approx. 0ohm

      Fig 2: Measuring Resistance Between Terminals 6 Of PCM Harness Connectors And 2 Of Vertical Resistor
      G03849318Courtesy of HYUNDAI MOTOR CO.
    4. Is resistance within the specification?

      YES: 

      • Go to "Check For Short To Ground In Harness" procedure.

      NO: 

  2. Check for short to ground in harness.
    1. Measure resistance between terminals 6 of the PCM harness connectors and chassis ground.

      Specification: Infinite

      Fig 3: Measuring Resistance Between Terminals 6 Of PCM Harness Connectors And Chassis Ground
      G03849319Courtesy of HYUNDAI MOTOR CO.
    2. Is resistance within the specification?

      YES: 

      • Go to next step below.

      NO: 

  3. Check for short to battery in harness.
    1. Ignition "ON" & Engine "OFF".
    2. Measure resistance between terminals 6 of the PCM harness connectors and chassis ground.

      Specification: Approx. 0V

      Fig 4: Measuring Resistance Between Terminals 6 Of PCM Harness Connectors And Chassis Ground
      G03849320Courtesy of HYUNDAI MOTOR CO.
    3. Is voltage within the specification?

      YES: 

      • Using a scan tool, check PCM software version and upgrade as necessary. If version is the newest one, go to "VERIFICATION OF VEHICLE REPAIR  " procedure.

      NO: