LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2005 >> Tiburon GS, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G4GC-GSL 2.0L) >> DTC Troubleshooting Procedures >> DTC P0335 Crankshaft Position Sensor A Circuit >> Component Inspection

Component Inspection

  1. Reconnect the CKPS and PCM connectors.
  2. Set up an oscilloscope as follows:

    Channel A (+): terminal 2 of the CKPS, (-): ground

    Channel B (+): terminal 2 of the CMPS, (-): ground

  3. Start the engine and check for signal waveform whether synchronize with camshaft sensor or not and tooth is missing.
    Fig 1: View Of Signal Waveform Graph
    G03849263Courtesy of HYUNDAI MOTOR CO.
  4. Is the signal waveform normal?

    YES: 

    • Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR  " procedure.

    NO: 

    • Remove CKP and calculate air gap between sensor and flywheel/torque converter. Readjust as necessary and go to next step.
      NOTE: Air gap [0.3~1.8 mm [0.012~0.067 in] = measure distance from housing to teeth on flywheel/torque converter (measurement "A") and from mounting surface on sensor to sensor tip (measurement "B") subtract "B" from "A".
    • If fail to synchronize with CMP sensor, readjust timing system and go to next step.
    • Check CKPS for contamination, deterioration, or damage. Substitute with a known-good CKPS and check for proper operation. If the problem is corrected, replace CKPS and then go to "VERIFICATION OF VEHICLE REPAIR  " procedure.