LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2005 >> Tiburon GS, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Fuel System (G4GC-GSL 2.0L) >> DTC Troubleshooting Procedures >> DTC P0011 "A" Camshaft Position-Timing Over-Advanced Or System Performance (Bank 1) >> Component Inspection >> Oil Control Valve Operation Check >> Notes

Oil Control Valve Operation Check: Notes

[With Scan Tool]

  1. Ignition "ON" & Engine "OFF"
  2. Install scan tool and select "CVVT VALVE" on the Actuation Test mode.
  3. Activates "CVVT VALVE" by pressing "STRT (F1)" key (should hear a faint click from oil control valve)
  4. Repeat this procedure 4 or 5 times to ensure oil control valve reliability.

    [Without Scan Tool]

  5. Ignition "OFF".
  6. Remove the oil control valve from the engine.
  7. Visually check the Spool Column of oil control valve for contamination.
  8. Connect 12V and a ground to 2 and 1 of the solenoid (Component side). Verify that the spool column moves to the left as shown in the figure.
    Fig 1: Identifying Spool Column Moves To The Left
    G03849136Courtesy of HYUNDAI MOTOR CO.
  9. Disconnect 12V and verify that spool column move to original condition.
  10. Has a problem been found?

    YES: 

    NO: 

    • Go to next step below