LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2005 >> Tiburon GS, Standard >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine (G4GC-GSL 2.0L) >> Engine Block >> Disassembly

Engine Block: Disassembly

  1. M/T: remove flywheel.
  2. A/T: remove drive plate.
  3. Install engine to engine stand for disassembly.
  4. Remove timing belt. (See REMOVAL )
  5. Remove cylinder head. (See REMOVAL )
  6. Remove oil level gauge assembly(A).
    Fig 1: Removing Oil Level Gauge Assembly
    G03848727Courtesy of HYUNDAI MOTOR CO.
  7. Remove knock sensor(A).
    Fig 2: Removing Knock Sensor
    G03848728Courtesy of HYUNDAI MOTOR CO.
  8. Remove oil pressure sensor(A).
    Fig 3: Removing Oil Pressure Sensor
    G03848729Courtesy of HYUNDAI MOTOR CO.
  9. Remove water pump. (See CAP TESTING )
  10. Remove oil pan(A).
    Fig 4: Removing Oil Pan
    G03848730Courtesy of HYUNDAI MOTOR CO.
  11. Remove oil screen.

    Remove the 2 bolts(C), oil screen(A) and gasket(B).

    Fig 5: Removing 2 Bolts, Oil Screen And Gasket
    G03848731Courtesy of HYUNDAI MOTOR CO.
  12. Check the connecting rod end play. (See INSPECTION )
  13. Remove the connecting rod caps and check oil clearance. (See INSPECTION  )
  14. Remove piston and connecting rod assemblies.
    1. Using a ridge reamer, remove all the carbon from the top of the cylinder.
    2. Push the piston, connecting rod assembly and upper bearing through the top of the cylinder block.
    NOTE:
    • Keep the bearings, connecting rod and cap together.
    • Arrange the piston and connecting rod assemblies in the correct order.
  15. Remove front case. (See REMOVAL )
  16. Remove rear oil seal case.

    Remove the 5 bolts(B) and rear oil seal case(A).

    Fig 6: Removing 5 Bolts And Rear Oil Seal Case
    G03848732Courtesy of HYUNDAI MOTOR CO.
  17. Remove crankshaft bearing cap and check oil clearance. (See  3 )
  18. Check the crankshaft end play. (See  4 )
  19. Lift the crankshaft(A) out of the engine, being careful not to damage journals.
    NOTE: Arrange the main bearings and thrust bearings in the correct order.
    Fig 7: Lifting Crankshaft Out Of Engine
    G03848733Courtesy of HYUNDAI MOTOR CO.
  20. Check fit between piston and piston pin.

    Try to move the piston back and forth on the piston pin. If any movement is felt, replace the piston and pin as a set.

  21. Remove piston rings.
    1. Using a piston ring expender, remove the 2 compression rings.
    2. Remove 2 side rails and the spacer by hand.
      NOTE: Arrange the piston rings in the correct order only.
  22. Disconnect connecting rod from piston.