LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2005 >> Tiburon GS, Standard >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Front Axle >> Front Hub/Knuckle >> Reassembly

Front Hub/Knuckle: Reassembly

  1. Apply multi-purpose grease to the contacting surface of the knuckle hub and bearing thinly.
  2. Using the special tools (09495-33100, 09517-29000), press-in the bearing to the knuckle.
    NOTE:
    1. Press-in the outer race of the wheel bearing to prevent damage to the bearing assembly.
    2. When installing a bearing assembly, always use a new one.
    Fig 1: Using Special Tools (09495-33100, 09517-29000) To Press-In Bearing To Knuckle
    G03849974Courtesy of HYUNDAI MOTOR CO.
  3. Install the dust cover.
  4. Using the special tool (09495-33100), press-in the hub to the knuckle.
    NOTE: Press-in the inner race of the wheel bearing to prevent damage to the bearing assembly.
    Fig 2: Using Special Tool (09495-33100) To Press-In Hub To Knuckle
    G03849975Courtesy of HYUNDAI MOTOR CO.
  5. Install the brake disc.
  6. Tighten the hub and the knuckle to the specified torque by using the special tool (09517-21500).

    Specified torque Nm (kgf.cm, lbf.ft) 

    2.0L: 200~260 (2000~2600, 148~192)

    2.7L: 200~280 (2000~2800, 148~207)

    Fig 3: Tightening Hub And Knuckle Torque Using Special Tool (09517-21500)
    G03849976Courtesy of HYUNDAI MOTOR CO.
  7. Rotate the hub several times to seat the bearing.
  8. Measure the hub bearing starting torque.

    Hub bearing starting torque [Limit] 

    1.8 Nm (18 kgf.cm, 1.33 lbf.ft) or less

    Fig 4: Measuring Hub Bearing Starting Torque
    G03849977Courtesy of HYUNDAI MOTOR CO.
  9. If the starting torque is 0 Nm (0 kgf.cm, 0 lbf.ft), measure the hub bearing axial play.
    Fig 5: Measuring Hub Bearing Axial Play
    G03849978Courtesy of HYUNDAI MOTOR CO.
  10. If the hub axial play exceeds the limit while the nut is tightened to 200~260 Nm (2000~2600Kgf.cm, 148~192 lbf.ft), the bearing, hub and knuckle are not installed correctly. Repeat the disassembly and assembly procedure.

    Hub bearing axial play [Limit] 

    0.008 mm (0.0003 in.) or less

  11. Remove the special tool (09517-21500)