LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2005 >> Tiburon GS, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> Abs (Anti-Lock Brake System) >> Abs Control >> NORMAL BRAKING With ABS

NORMAL BRAKING With ABS

  1. DUMP MODE 
    SOLENOID VALVE DUMP MODE SPECIFICATIONS

    Solenoid State Valve Passage Pump motor
    Inlet valve (NO) ON CLOSE Master cylinder - Wheel cylinder ON
    Outlet valve (NC) ON OPEN Wheel cylinder - Reservoir

    If the wheel speed decreases, there is still a tendency to lock; the brake pressure on the corresponding wheel must be reduced accordingly. For this, the outlet valve 0V is opened, the inlet valve IV remains closed.

    The brake pressure to the low-pressure accumulator is reduced. The wheel in danger of locking gains speed again.

    Fig 1: Identifying DUMP MODE
    G03850364Courtesy of HYUNDAI MOTOR CO.
  2. HOLD MODE 
    SOLENOID VALVE HOLD MODE SPECIFICATIONS

    Solenoid State Valve Passage Pump motor
    Inlet valve (NO) ON CLOSE Master cylinder - Wheel cylinder OFF
    Outlet valve (NC) OFF CLOSE Wheel cylinder - Reservoir

    When a wheel (or several) tends to lock the inlet valve IV is first closed to avoid a further increase in brake pressure. The outlet valve 0V remains closed: the brake pressure is kept constant.

    Fig 2: Identifying Hold Mode
    G03850365Courtesy of HYUNDAI MOTOR CO.
  3. INCREASE MODE 
    SOLENOID VALVE INCREASE MODE SPECIFICATIONS

    Solenoid State Valve Passage Pump motor
    Inlet valve (NO) OFF OPEN Master cylinder - Wheel cylinder ON
    Outlet valve (NC) OFF CLOSE Wheel cylinder - Reservoir

    For optimum brake from the certain wheel acceleration a brake pressure increase is necessary. For this, the inlet valve IV is opened and the outlet valve 0V is closed. The pump of the unit starts to run and aspirates the necessary quantity of fluid from the Low-pressure accumulator, in order to produce the necessary brake pressure for the pressure increase phase in seconds.

    With an increase in the brake pressure the wheel speed is reduced. These control phases are repeated until the ABS control unit no longer detects any tendency of the wheels to lock.

    NOTE: During ABS control function, the brake pedal only moves in accordance with the volume requirement of the wheels. Because of a sudden change in friction coefficient this pedal movement may increase slightly.
    Fig 3: Identifying Increase Mode
    G03850366Courtesy of HYUNDAI MOTOR CO.