Diagnosis Of Immobilizer Faults: Notes
The diagnosis monitors :
- Communication between the ECM and the BCM
- Function of the BCM and the transponder, and
- Data (stored in the ECM) related to the immobilizer function
There are four different faults that are assigned to the immobilizer system. Every fault is broken down into four different types (circuit malfunction, circuit range / performance problem, low input, high input). The following table shows the assignment of immobilizer related faults to each type:
IMMOBILIZER FAULTS DIAGNOSIS
| Type | Diagnostic Codes | Immobilizer Related Faults | Fault Types |
|---|---|---|---|
| SMARTRA (2.0 beta ENGINE) | P1610 | BCM fault | No answer from the BCM Invalid message from BCM to ECM |
| P1800 | Antenna error | ||
| P1803 | Invalid request from ECM or corrupted data | ||
| P1801 | Transponder fault | Invalid transponder data Passive mode invalid Programming error |
|
| P1805 | EEPROM | Inconsistent data of EEPROM Invalid write operation to EEPROM |
|
| ECM fault | No valid data from ECM after 3 attempts by ECM Invalid tester message or unexpected requests by tester |
||
| STAND ALONE (2.7 delta ENGINE) | 01 | Untaught transponder | Untaught transponder |
| 02 | Transponder communication error | Transponder error due to a wrong code or bad read (wrong transponder in field, or more than one transponder in the field). | |
| 03 | ECM communication error | ECM error due to bad Service ID (SID), Bad Message ID (MID) or protocol errors | |
| 04 | Immobilizer antenna - open | Open Immobilizer antenna | |
| 05 | BCM internal fault or EEPROM | BCM internal fault (smart driver failure) or BCM EEPROM error | |
| 06 | ECM not detected | ECM not detected |