Air Bleeding
- Fill the power steering reservoir up to the "MAX" position with the specified fluid.NOTE:
- When bleeding fluid, replenish the fluid so that the level never falls below the bottom of the fitter.
- If air bleeding is done while the vehicle is idling, the air will be broken up and absorbed into fluid. Be sure to do the bleeding only while cranking.
- Disconnect the high tension cable and then, while operating the starting motor intermittently (for 15~20 seconds), turn the steering wheel all the way to the left and then to the right five or six times.
- Connect the high tension cable, and start the engine (idling).
- Turn the steering wheel to the left and the right until there are no air bubbles in the oil reservoir.
- Confirm that the fluid is not milky, and that the level is between "MAX" and "MIN" marks on the reservoir.
- Check that there is any change in the fluid level when the steering wheel is turned left and right.NOTE:
- If the fluid level varies 5 mm (0.2 in.) or more, bleed the system again.
- Turn the steering wheel left and right until there are not bubbles in the oil reservoirs.
- If the air isn't removed perfectly, it can cause cavitation in the pump and noise, and may damage the pump.