LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2004 >> XG350 Base >> Repair and Diagnosis >> Steering >> Power Steering >> Steering System >> Mechanical Power Steering System >> Power Steering Oil Pump >> Assembly

Power Steering Oil Pump: Assembly

  1. Install the oil pump switch.
  2. Install the flow control valve spring, valve and connector in the pump body.
    NOTE: Apply a thin coat of power steering fluid to all parts including the oil seal and O-ring.
  3. Install the guide bracket and nut.
  4. Using special tool (09222-32100), install the oil seal into the pump body.
    Fig 1: Installing Oil Pump Seal
    G00721944Courtesy of HYUNDAI MOTOR CO.
  5. Gently insert the shaft assembly and install the snap ring.
    Fig 2: Installing Shaft Assembly
    G00721945Courtesy of HYUNDAI MOTOR CO.
  6. Install the pump pulley and woodruff key in place.
  7. Install the spring and the inner and outer O-rings.
  8. Install the front side plate.
    Fig 3: Installing Inner, Outer "O" Rings & Front Side Plate
    G00721946Courtesy of HYUNDAI MOTOR CO.
  9. Insert the pins into the pin grooves of the front housing, then install the cam ring, paying attention to its direction.
    Fig 4: Installing Cam Ring
    G00721947Courtesy of HYUNDAI MOTOR CO.
  10. Install the rotor with its punch marked side facing towards the front side plate.
  11. Install the vane plates with the round end facing outward.
    Fig 5: Installing Rotor & Vane Plates
    G00721948Courtesy of HYUNDAI MOTOR CO.
  12. Install the gasket and rear cover.
  13. Tighten the suction connector.