Power Steering Oil Pump: Disassembly
- After removing the 2 bolts (10mm), remove the suction pipe and the O-ring from the oil pump body.
- Loosen the four bolts (12mm) and remove the oil pump cover assembly.
- Remove the cam ring.
- Remove the shaft fixing ring using snap ring pliers.
- Remove the rotor and vanes.
- Remove the oil pump side plate.
- Remove the pulley and shaft assembly from the oil pump body.
- Remove the oil seal from the oil pump body.
- Remove the connector (24mm) from the oil pump body, and take out the flow control valve and the flow control spring.
- Remove the O-ring from the connector.
CAUTION:
Do not disassemble the flow control valve.