Power Steering Hoses: Removal
- Support the specified point of the vehicle with a lift.
- Drain the power steering fluid.
- Remove the front tires (RH/LH).
- After removing the split pin, disconnect the tie rod from the knuckle using a special tool (09568-34000).
Courtesy of HYUNDAI MOTOR CO.
- Disconnect the shaft assembly from the gear box inside the passenger compartment.
Courtesy of HYUNDAI MOTOR CO.
- Raise up the vehicle.
- Loosen the power steering pressure tube mounting clamp and return tube mounting clamp mounting bolt.
Courtesy of HYUNDAI MOTOR CO.
- Disconnect the pressure tube and return tube fitting from the power steering gear box.
Courtesy of HYUNDAI MOTOR CO.
- Lower the vehicle and disconnect the pressure hose connector from the oil pump. (When removing the pressure hose)
Courtesy of HYUNDAI MOTOR CO.
- Disconnect the pressure hose assembly. (When removing the pressure hose)
Courtesy of HYUNDAI MOTOR CO.
- After removing the clip from the color tube, removing the return tube and hose. (When removing the return tube and hose)
Courtesy of HYUNDAI MOTOR CO.
- Remove the 10mm color tube mounting clip bolt. (When removing the color tube)
Courtesy of HYUNDAI MOTOR CO.
- Disconnect the remove the color tube from the power steering oil reservoir tank side hose. (When working on the color tube)
Courtesy of HYUNDAI MOTOR CO.