LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2003 >> XG350 L >> Repair and Diagnosis >> Body & Frame >> Power Windows >> Power Windows >> Power Window Motor (Rear) >> Removal & Installation

Removal & Installation

  1. Remove the rear door inside handle housing.
    Fig 1: Removing Inside Door Handle Housing
    G01100296Courtesy of HYUNDAI MOTOR CO.
  2. Remove the door trim panel by using a trim panel remover.
    Fig 2: Releasing Door Trim Panel Fasteners
    G01100297Courtesy of HYUNDAI MOTOR CO.
  3. Disconnect the power window switch and the door courtesy lamp connector.
    Fig 3: Disconnecting Power Window Switch & Door Courtesy Lamp Connectors
    G01100298Courtesy of HYUNDAI MOTOR CO.
  4. Remove the door pull handle mounting bracket, door inside handle and door trim seal.
    Fig 4: Removing Door Pull Handle Mounting Bracket, Inside Handle & Door Trim Seal
    G01100299Courtesy of HYUNDAI MOTOR CO.
  5. Remove the door glass stopper catch.
    Fig 5: Removing Door Glass Stopper Catch
    G01100300Courtesy of HYUNDAI MOTOR CO.
    NOTE: Does not remove the door glass stopper if you don't want to change the door glass.
  6. Remove the carrier plate mounting bolts from the door regulator channel and remove the door glass.
    Fig 6: Removing Door Glass
    G01100301Courtesy of HYUNDAI MOTOR CO.
  7. Remove the door regulator after removing the mounting bolts.
    Fig 7: Removing Window Regulator
    G01100302Courtesy of HYUNDAI MOTOR CO.
  8. Installation is the reverse of removal.
    CAUTION: When installing the door trim seal, butyl tape should not be placed over door trim fastener mounting area.