Test Procedures
- Turn ignition on. Install scan tool to data link connector, and verify DTC P0442 is set. If DTC P0442 only is set, go to next step. If DTC P0443, P0443 and/or P0450 is also set, repair these DTC first. When repairs are completed, clear DTCs and verify EVAP system operation.
- Start engine and allow to idle. Check EVAP control system vacuum hoses for vacuum leaks and clogs. Repair any vacuum leaks or clogged hoses, and recheck for DTCs. If no problems are found, go to next step. When repairs are completed, clear DTCs and verify EVAP system operation.
- Turn ignition off. Disconnect canister purge control solenoid valve 2-pin connector. Turn ignition on. Measure voltage between ground and purge control solenoid valve connector terminal No. 2 (Pink wire). If battery voltage is present, go to next step. If battery voltage is not present, repair open or short to ground in Pink wire between purge control solenoid and engine control relay. When repairs are completed, clear DTCs and verify EVAP system operation.
- Disconnect ECM connector C44-1 (A/T) or C45-1 (M/T). Using a jumper wire, connect purge control solenoid valve harness connector terminal No. 1 (Green/White wire) to ground. Measure resistance between ground and ECM harness connector C44-1 (A/T) terminal No. 34, or connector C45-1 (M/T) terminal No. 9. If resistance is one ohm or less, go to next step. If resistance is more than one ohm, repair open or short to ground in wire between purge control solenoid and ECM. When repairs are completed, clear DTCs and verify EVAP system operation.
- Remove jumper wire. Check for continuity between ground and purge control solenoid harness connector terminal No. 1 (Green/White wire). If continuity does not exist, go to next step. If continuity exists, repair short to ground in Green/White wire between purge control solenoid and ECM. When repairs are completed, clear DTCs and verify EVAP system operation.
- Measure resistance between purge control solenoid valve terminals. If resistance is about 27 ohms, verify ECM connector terminals are clean and tight. If ECM connectors are okay, replace ECM. If resistance is not about 27 ohms, replace solenoid. When repairs are completed, clear DTCs and verify EVAP system operation.