Test Procedures
NOTE:
It is recommended that vehicle cool down overnight before starting ECT sensor test procedure.
- Turn ignition on. Install scan tool to data link connector, and verify DTC P0115 is set. If DTC P0110 is set, go to DTC P0110: INTAKE AIR TEMPERATURE (IAT) SENSOR CIRCUIT MALFUNCTION and repair DTC P0110 first. If DTC P0115 is set, go to next step. If DTC P0115 is not set, ensure ECT sensor and ECM connectors are clean and tight. Perform repairs as necessary. When repairs are completed, clear DTCs and verify ECT sensor operation.
- Allow engine to cool overnight. Measure and record shop ambient air temperature. Turn ignition on. Using a scan tool, monitor ECT sensor and IAT sensor temperatures. If both monitored temperatures agree with shop ambient air temperature, go to next step. If IAT sensor temperature deviates from shop temperature, go to DTC P0110: INTAKE AIR TEMPERATURE (IAT) SENSOR CIRCUIT MALFUNCTION . If ECT sensor temperature deviates from shop temperature, replace ECT sensor. When repairs are completed, clear DTCs and verify ECT sensor operation.
- Turn ignition off. Disconnect ECT sensor. Turn ignition on. Measure voltage between ECT sensor harness connector terminals. If voltage is less than 4.5 volts, go to next step. If voltage is 4.5-5.0 volts, replace ECT sensor. When repairs are completed, clear DTCs and verify ECT sensor operation.
- Turn ignition off. Disconnect ECT sensor connector and ECM C44-2 (A/T) connector or C45-4 (M/T) connector. Using a jumper wire, connect ECT sensor connector terminal No. 1 (Green wire) to ground. Measure resistance between ground and ECM C44-2 (A/T) connector terminal No. 4 (Green wire) or C45-4 (M/T) terminal No. 13 (Green wire). If resistance is one ohm or less, remove jumper wire and go to next step. If resistance is more than one ohm, repair open in Green wire between ECT sensor and ECM. When repairs are completed, clear DTCs and verify ECT sensor operation.
- Turn ignition off. Disconnect ECT sensor connector and ECM C44-2 (A/T) connector or C45-4 (M/T) connector. Check for continuity between ground and ECM C44-2 (A/T) connector terminal No. 4 (Green wire) or C45-4 (M/T) terminal No. 13 (Green wire). If continuity does not exist, go to next step. If continuity exists, repair short to ground in Green wire between ECT sensor and ECM. When repairs are completed, clear DTCs and verify ECT sensor operation.
- Turn ignition off. Disconnect ECT sensor connector and ECM C44-2 (A/T) connector or C45-4 (M/T) connector. Check for continuity between ground and ECT sensor connector terminal No. 2 (Black/White wire). If continuity does not exist, ensure ECM connector is clean and tight. If connector is okay, replace ECT sensor. Clear DTCs and verify ECT sensor operation. If problem persists, replace ECM. If continuity exists, repair short to ground in Black/White wire between ECT sensor and ECM C44-2 (A/T) connector terminal No. 17 or C45-4 (M/T) terminal No. 22. When repairs are completed, clear DTCs and verify ECT sensor operation.