LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 1996 >> Accent Base, 2D Hatchback, Automatic >> Repair and Diagnosis >> Quick Lookups >> Technical Bulletins >> Technical Service Bulletins >> Transmission Control Systems >> Powertrain Control Module (Pcm) Removal/Installation Procedure (Shop Manual Addition) (96-36-005)

Powertrain Control Module (Pcm) Removal/Installation Procedure (Shop Manual Addition) (96-36-005)

Publication date: 1996-07-01
Reference number: 96-36-005

POWERTRAIN CONTROL MODULE (PCM) REMOVAL/INSTALLATION PROCEDURE (SHOP MANUAL ADDITION)

POWERTRAIN CONTROL MODULE (PCM) REMOVAL/INSTALLATION PROCEDURE (SHOP MANUAL ADDITION)

TECHNICAL SERVICE BULLETIN

Reference Number(s): 96-36-005, Date of Issue:  July, 1996
HYUNDAI: Accent 1996
GROUP: 36 - Engine Electrical

DESCRIPTION

The 1996 Accent Shop Manual does not contain procedures for removal and installation of the Powertrain Control Module (PCM). Please include these procedures by writing down the TSB number on the appropriate pages in your Shop Manual for future reference.

REMOVAL PROCEDURES

  1. Record the customer's radio stations and the negative battery cable.
    Fig 1: Disconnecting Negative Battery Cable
    G04588987Courtesy of HYUNDAI MOTOR CO.
  2. Locate the Transaxle Control Module (TCM) under the dashboard near the brake pedal. The TCM must be moved to the side to allow faster access to the PCM mounting bolts.
    Fig 2: Locating Transaxle Control Module (TCM)
    G04588988Courtesy of HYUNDAI MOTOR CO.
  3. Remove two (2) 10 mm bolts from the TCM bracket against the firewall and rotate it to the right and out of the way.
    Fig 3: Locating PCM And TCM Connector
    G04588989Courtesy of HYUNDAI MOTOR CO.
  4. Disconnect the harness from the PCM and remove two (2) 12 mm bolts.
  5. Slide the PCM unit out from its base bracket.
    Fig 4: Removing PCM
    G04588990Courtesy of HYUNDAI MOTOR CO.
  6. Remove the computer mounting bracket from the PCM.

INSTALLATION PROCEDURES

  1. Reinstall the mounting bracket to the PCM.
  2. Reinstall the PCM and its mounting bracket to the base bracket with the two (2) 12 mm bolts.
  3. Reconnect the harness to the PCM.
  4. Reinstall the TCM with the two (2) 10 mm bolts.
  5. Reconnect the negative battery cable and reset the customer's radio stations and clock.