DTC P1611/P1614 - Mil Request Signal Circuit
- P1611 - Signal Circuit Low Input
- P1614 - Signal Circuit High Input
- Install scan tool. Start engine and check if DTC P1611 or P1614 is present. If DTC is present, go to next step. If DTC is not present, problem is intermittent.
- Turn ignition off. Check circuit between ECM terminal No. 61 and TCM harness connector. Also, check ECM and TCM terminal contacts. See appropriate wiring diagram in WIRING DIAGRAMS section. Repair as necessary. If circuit and terminals are okay, go to next step.
- Replace TCM with a known-good unit. Clear DTC. See CLEARING DTC(S) . Retest system. Recheck DTC. If DTC resets, replace TCM.