LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2006 >> H3 Standard >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Steering Wheel And Column >> Repair Instructions >> Intermediate Steering Shaft Replacement - Upper >> Installation Procedure

Installation Procedure

  1. Install the upper intermediate shaft to the column.
  2. NOTE: Refer to Fastener Notice .
    IMPORTANT: The upper intermediate shaft to the steering column pinch bolt must be installed in the same direction it was removed or the pinch bolt will contact the steering column housing.
  3. Install the upper intermediate shaft pinch bolt.

    Tighten:  Tighten the upper intermediate shaft to steering column pinch bolt to 23 N.m (17 lb ft).

  4. Install the steering column. Refer to Steering Column Replacement .
  5. Fig 1: View Of Upper Intermediate Shaft To Dash Nuts
    GM1207223Courtesy of GENERAL MOTORS CORP.
  6. From inside the vehicle install the upper intermediate shaft to dash stud nuts.

    Tighten:  Tighten the upper intermediate shaft nuts to 23 N.m (17 lb ft).

  7. Raise the vehicle.
  8. Fig 2: View Of Upper Intermediate Shaft & Lower Intermediate Shaft Pinch Bolt
    GM1207224Courtesy of GENERAL MOTORS CORP.
  9. Install the upper intermediate shaft to the lower intermediate shaft pinch bolt.

    Tighten:  Tighten the upper intermediate shaft pinch bolt to 23 N.m (17 lb ft).

  10. Lower the vehicle.
  11. Remove the J 42640  .