Power Window Motor Test: Test: Driver's
- Front Door Panel - Remove
- Driver's Power Window Motor - TestNOTE: Before testing, make sure not to short the power window motor circuit.
1. Disconnect the power window switch connector (A), then reconnect the door subharness connectors (B).
2. Test the motor in each direction by connecting 12 volt battery power and ground to the connector according to the table. When the motor stops running, disconnect 12 volt battery power immediately.
3. If the motor does not run or fails to run smoothly, remove the door panel, then go to step 4.
4. Remove the driver's door speaker
5. Test the motor (A) by connecting 12 volt battery power and ground according to the table. When the motor stops running, disconnect 12 volt battery power immediately.
6. If the motor does not run or fails to run smoothly, the driver's power window motor is faulty; replace the driver's door regulator
7. If the motor runs smoothly, replace the wire harnesses or adjust the driver's door glass .
- All Removed Parts - Install
1. Install the parts in the reverse order of removal. - Power Window Control Unit - Reset