LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2016 >> Civic EX >> Repair and Diagnosis >> Brakes >> Traction Control >> VSA System - DTC Diagnostics >> DTC Troubleshooting >> DTC U3000-54 (VSA Control Unit)

DTC U3000-54 (VSA Control Unit)

DTC U3000-54  : Sensor Calibration is Not Completed

NOTE: Before you troubleshoot, review the general troubleshooting information. 

DTC Description DTC Freeze Frame
U3000-54 Sensor Calibration is Not Completed    

DTCs (VSA)

  1. VSA sensor neutral position memorization

    -1. Turn the vehicle to the ON mode.

    -2. Do the VSA sensor neutral position memorization .

    -3. Clear the DTC with the HDS.

    -4. Turn the vehicle to the OFF (LOCK) mode.

    -5. Test-drive the vehicle at 6 mph (10 km/h) or more.

    NOTE:  Drive the vehicle on the road, not on a lift.

    -6. Check for DTCs with the HDS.

    DTC Description DTC Freeze Frame
    U3000-54 Sensor Calibration is Not Completed    

    Is DTC U3000-54 indicated?

    YES 

    Check for loose terminals and poor connections in the VSA modulator-control unit 46P connector. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting. If they are OK, replace the VSA modulator-control unit .

    NO 

    Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the Freeze data/on-board snapshot.