LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2014 >> Pilot EX, FWD >> Repair and Diagnosis >> Electrical >> Gauges >> Electrical Compass System >> Electrical Compass Zone Selection and Calibration >> Zone Selection

Zone Selection

  1. Turn the ignition switch to ON (II).
  2. Press and hold the SETUP button until you hear a beep (about 5 seconds). The display shows the electrical compass setting menu items.
    Fig 1: Display - Electrical Compass Setting Menu (With USB Adapter)
    G08091265Courtesy of AMERICAN HONDA MOTOR CO., INC.
    Fig 2: Display - Electrical Compass Setting Menu (Without USB Adapter, With Climate Control)
    G08091266Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Rotate the SELECTOR knob to select the Zone Adjust (A) or ZONE (B) and press the SELECTOR knob to enter the selection.
    NOTE: If necessary, press the RETURN button to return to the previous display. Pressing the SETUP button cancels the electrical compass setting mode.
  4. The display shows the currently selected zone number between from 1 to 15. Find the zone for your area on the zone map. If the correct zone is not shown, turn the selector knob to cycle the zone lists up or down.
    Fig 3: Display - Zone Selection Area
    G08091267Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Press the SELECTOR knob to decide the selected zone. Returning to the normal display, the zone selection mode ends.