LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2014 >> Civic Hybrid >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System & Engine Mechanical - Testing & Troubleshooting (Hybrid) >> Testing >> Camshaft Inspection >> Inspection

Camshaft Inspection: Inspection

  1. Camshaft - Inspection 
    GHH124036Courtesy of HONDA, U.S.A., INC.
    1. Loosen the camshaft holder bolts two turns at a time. Then remove the camshaft holders from the cylinder head.

    2. Lift the camshaft out of the cylinder head, wipe it clean, then inspect the lift ramps. Replace the camshaft if any lobes are pitted, scored, or excessively worn.

    3. Clean the camshaft journal surfaces in the cylinder head, then set the camshaft back in place. Place a plastigage strip across each journal.

    4. Install the camshaft holders, then tighten the bolts to the specified torque as shown.

    5. Remove the camshaft holders. Measure the widest part of plastigage on each journal:

    • If the camshaft-to-holder clearance is within limits, go to step 7.
    • If the camshaft-to-holder clearance is beyond the service limit, and the camshaft has been replaced, replace the cylinder head.
    • If the camshaft-to-holder clearance is beyond the service limit, and the camshaft has not been replaced, go to step 6.
    Camshaft-to-Holder Oil Clearance
    Standard (New): 0.050-0.089 mm (0.00197-0.00350 in)
    Service Limit: 0.10 mm (0.0039 in)
    GHH118041Courtesy of HONDA, U.S.A., INC.
    GHH124037Courtesy of HONDA, U.S.A., INC.
    6. Check the total runout with the camshaft supported on V-blocks.
    • If the total runout of the camshaft is within the service limit, replace the cylinder head.
    • If the total runout is beyond the service limit, replace the camshaft, and recheck the oil clearance. If the oil clearance is still beyond the service limit, replace the cylinder head.
    Camshaft Total Runout
    Standard (New): 0.03 mm (0.0012 in) max.
    GHH124038Courtesy of HONDA, U.S.A., INC.
    7. Measure the cam lobe height.

    Cam Lobe Height Standard (New):

      INTAKE EXHAUST
    PRI 29.700 mm (1.16929 in) 29.900 mm (1.17716 in)
    SEC 35.854 mm (1.41157 in) 35.516 mm (1.39827 in)

    PRI: Primary SEC: Secondary

    8. Remove the rocker shaft holders and the lost motion holder.