EGR Monitor and Readiness Code
NOTE:
- Do not turn the ignition switch to ACC (I) or to LOCK (0) during the procedure.
- All readiness codes are cleared when the 12 volt battery is disconnected, if DTCs have been cleared, or if the PCM is reset with the HDS.
Enable Criteria
ECT SENSOR 1 at 176 °F (80 °C) or more.
Procedure
- 1. Connect the HDS to the DLC.
- 2. Start the engine.
- 3. Drive at a steady speed, with the transmission in D, at 50-62 mph (80-100 km/h) or above for more than 10 seconds.
- 4. With the transmission in D, decelerate from 62 mph (100 km/h) or above by completely releasing the throttle for at least 5 seconds. If the engine is stopped during this step, repeat step 3 and 4.
- 5. Check the OBD status screen for DTC P0401 in the DTC's MENU with the HDS.
-
- If it is passed, readiness is complete.
- If it is not passed, go to step 3 and retest.