LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2009 >> Ridgeline V6-3.5L >> Repair and Diagnosis >> Body and Frame >> Weatherstrip >> Trunk / Liftgate Weatherstrip >> Service and Repair

Trunk / Liftgate Weatherstrip: Service and Repair




In-Bed Trunk Lid Weatherstrip Replacement

1. Remove the in-bed trunk lid weatherstrip (A) and in-bed trunk lid edge weatherstrip (B) by pulling them off.






2. Hold the in-bed trunk lid (A) slightly open, and pull out the in-bed trunk lid weatherstrip (B) from between the lid and side bed panels (C), then remove the weatherstrip.






3. Locate the painted alignment marks (A) on the in-bed trunk lid edge weatherstrip (B) and the in-bed trunk lid weatherstrip (C). Align the painted mark and the bonded end position (D) in the center of the in-bed trunk lid, and install the in-bed trunk lid weatherstrips all the way around as shown. Make sure there are no wrinkles in the weatherstrips.

4. Check for water leaks.