ODS Unit Initialization
When a seat-back cover, seat-back cushion, and/or ODS unit is replaced, do this procedure to initialize the ODS unit.
NOTE:
- A new (uninitialized) ODS unit installed with a faulty OPDS sensor can cause DTC 85-71.
- Before initializing the ODS unit, make sure the battery is fully charged.
- Clear the DTC memory (see CLEAR THE DTC MEMORY WITH THE HDS ).
- Make sure the front passenger's seat is dry. Set the seat-back in a normal position, and make sure there is nothing on the seat.
- Make sure the ignition switch is in LOCK (0) and the MES connector is not shorted.
- Connect the HDS to the data link connector (DLC) (A).
- Turn the ignition switch to ON (II).
- Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate, troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING ).
- From the HDS Main Menu, select SRS, then SRS, then Adjustments. In the Adjustment Menu, select ODS INIT. Follow the screen prompts to initialize the ODS.
- Turn the ignition switch to LOCK (0).
- Disconnect the HDS from the DLC.
NOTE:
If the ODS system fails to initialize after several attempts, replace the OPDS sensor/seat-back and retry. If the ODS unit continues to fail to initialize, replace the ODS unit (see
ODS UNIT REPLACEMENT ).