DTC 68: Brake Pedal Position Switch
- Turn the ignition switch to ON (II).
- Check for other DTCs.
Is another DTC indicated?
YES - Do the appropriate troubleshooting for the DTC.
NO - Go to step 3.
- Turn the ignition switch to LOCK (0).
- Check the brake pedal position switch (see BRAKE PEDAL POSITION SWITCH TEST
), and adjustment (see BRAKE PEDAL AND BRAKE PEDAL POSITION SWITCH ADJUSTMENT
).
Is the switch and adjustment OK?
YES - Go to step 5.
NO - Adjust the brake pedal position switch. If necessary, replace the switch (see BRAKE PEDAL AND BRAKE PEDAL POSITION SWITCH ADJUSTMENT ).
- Turn the ignition switch to ON (II).
- Clear the DTC with the HDS.
- Test-drive the vehicle.NOTE: Drive the vehicle on the road, not on a lift.
- Check for DTCs with the HDS.
Is DTC 68 indicated?
YES - Go to step 9.
NO - The system is OK at this time.
- Troubleshoot the brake pedal position switch signal circuit (see BRAKE PEDAL POSITION SWITCH SIGNAL CIRCUIT TROUBLESHOOTING
).
Is the brake pedal position switch circuit OK?
YES - Go to step 10.
NO - Repair the brake pedal position switch circuit.
- Update the ECM/PCM if it does not have the latest software (see UPDATING THE ECM/PCM ), or substitute a known-good ECM/PCM (see SUBSTITUTING THE ECM/PCM ).
- Clear the DTC with the HDS.
- Test-drive the vehicle.NOTE: Drive the vehicle on the road, not on a lift.
- Check for DTCs with the HDS.
Is DTC 68 indicated?
YES - Check for loose terminals in the ECM/PCM connector E (31P). If the ECM/PCM was updated, substitute a known-good ECM/PCM (see SUBSTITUTING THE ECM/PCM ), then retest. If the ECM/PCM was substituted, replace the VSA modulator-control unit (see VSA MODULATOR-CONTROL UNIT REMOVAL AND INSTALLATION ).
NO - If the ECM/PCM was updated, troubleshooting is complete. If the ECM/PCM was substituted, replace the original ECM/PCM (see ECM/PCM REPLACEMENT ).